Specter manufactures performance parts for your vehicle. Specter air filters are agnate to K&N air filters. They act not must to replaced; they can be cleaned, re-oiled then re-used. Specter recommends properly cleaning your filter once every 7,000 miles for bad results, however the particular room depends on the type of climate in which you you alive. Under no circumstances should you hardihood besides than 25,000 miles without cleaning your filter, according to Specter.
Instructions
1. Build persuaded you effect not itch your vehicle for at least assorted hours. Cleaning, drying and re-oiling the filter may revenue three to five hours. Discharge not coerce your vehicle without its filter in put.
2. Remove the Specter air filter from your air box. This measure varies between vehicles, on the other hand most air box's obtain outer clamps at Everyone corner. Whether this is the context, lift the clamps to access the filter. Other vehicles call screws or bolts. Remove the screws or bolts with the apt belongings to access the filter.
3. Dominance the filter with the muddy side facing you. Contain the filter into a rubbish bin and tap it against the inside edge to shake out the large particles of dust and dirt. Don't do this inside; the dust is likely to flow into the air. Wear a dust mask if you are sensitive.
4. Apply the Spectre cleaning solvent to the filter liberally. Let the solvent soak for 10 to 15 minutes. This helps to break up the smaller particles.
5. Check the filter periodically to see if it's dry.7. Spray the proper amount of Spectre filter oil onto the filter. The exact amount depends on the filter model number.
6. Air dry the filter. Allow the filter to sit outdoors, preferably in sunlight, until it is dry. This should take several hours, but may take longer. Run warm water over the filter to rinse out the solvent, further as the dirt and dust. Continue the process until the water runs clear. This means the filter is clean.
Refer to your maintenance guide and instruction booklet, if you still have it. Otherwise, locate the part number on the side of the filter and look up the proper amount of oil. It's very important not to over-oil the filter, according to Spectre. Re-insert the filter when you are finished.
