Front and rear door panels of a Suburban are removed in homogenous way. Corner the screwdriver gently into the rear of the switch and pry upwards. Lift the switch up and remove the electrical connector.3. Remove the plastic V-shaped insert over the attachment aim for the away rear-view mirror.
Instructions
1. Remove the two screws located in the armrest with the Phillips screwdriver. This is the central collar for the panel. Remove the screw in the front on the door handgrip using the Phillips screwdriver.
2. Remove the skilled window switch using the regular screwdriver. They are make-believe of a concentrated cardboard backing that is agnate to peg board nevertheless without the holes. Snaps on the back of the door panel are used to clasp the gone of the door panel in compass. Affliction must be taken when removing the snaps so that the cardboard backing is not damaged. The snaps should be worked gone with no pulling on the panel itself.
Practice the customary screwdriver to gently pry the insert off. It is held on with plastic snaps.
4. Remove the door panel using the typical screwdriver. There are snaps on all three sides of the panel. City the bourgeois screwdriver at the top of the panel in-between the door panel and the door. Slide the screwdriver down until it contacts the snap and pry the snap elsewhere of the recess in the door. Engage in the same to all the snaps.
5. Lift the bottom of the door panel outwards a few inches, then lift it up to release the top section of the panel from the horizontal bar. Remove the marker light electrical connector from the bottom rear of the panel.
