Wednesday, April 1, 2015

Install An Ignition Turn On A Chevrolet Pickup

The ignition switch in your Chevrolet Motor lorry isn't the solid meeting on the steering column, rather dependable the electric switch connected to the lock cylinder. Provided the switch is damaging (check it by turning the principal and seeing provided the warning lights come on), you must install a replacement switch. There can be some variations on the procedure, so consult an automotive operate for your particular year and design.


Instructions


1. On some models, you must besides remove the Chauffeur's side knee bolster.3. Disconnect and remove the grassland lock switch from the lock cylinder housing; this is needed on some mid-size trucks liking the Colorado. Disconnect the lock's electrical connector, and depress its tab with a immature screwdriver to Proceeds the switch.


Sincere the hood and disconnect the con cable from your Motor lorry's battery.2. Remove the covers from the steering path by removing the screws from the backside incorporate; the upper involve should come go off after the lower one.



4. Involve the vital, and turn it to the "On" or "Fall" position. On some mid-size models you must turn it the other behaviour into the "Frill" position. Incorporate the retainer pin into the gap in the lock cylinder, and pull the cylinder out of the steering column.


5. Disconnect the electrical connectors for the ignition switch from the cylinder--there can be one or two of them, depending on the model, and one of them can require twisting. Then remove the switch from the cylinder by pulling out its screws.


6. Screw the replacement switch in position on the lock cylinder, and connect its wiring harness (or harnesses) to the electrical connector(s).


7. Insert the lock cylinder in the same position it was in when you removed it, aligning the lock's retainer with the slot in the steering column housing. Press the cylinder in until the retainer activates.


8. Replace all other components in reverse order of removal.