Exchange the brake pads on your 2000 Pontiac Grand Am.
The brake pads on the 2000 Pontiac Grand Am are designed to site the van by applying friction to the brake rotors as they are turning. The pads are enclosed inside of the brake caliper. When the brake pedal is pushed in, the cylinder inside of the brake caliper pushes the outer brake pad against the facing of the rotor. This, in turn, pulls the inner brake pad against the inner facing of the rotor. The friction of the pads sliding against the rotors is the manner that stops the Grand Am.
Instructions
1. Stadium your 2000 Pontiac Grand Am in a defended working residence on a constant surface. Allot the emergency brake and unlatched the hood.
2. Remove the lid from the brake fluid reservoir. Encompass the tube of a brake fluid syringe into the brake fluid and suck gone a syringe adequate of brake fluid. Place the lid back on the reservoir and lower the hood.
3. Slide a floor jack under the front boundary of your 2000 Pontiac Grand Am and position the jack under a jacking stop. Up thrust the Grand Am gigantic Sufficiently for the jack stands to fit under the motorcar. Position the jack stands underneath the frame condemn on both sides of the automobile. Lower the Grand Am to the top of the stands.
Loosen Everyone of the lug nuts from the front wheels by turning the lug nuts counterclockwise approximately 1/4 of a turn with a tire object. Accomplish not remove the lug nuts.4. As soon as the weight of the machine is on the stands, cease the jack and allowance it in the upright position.
5. Remove all of the lug nuts from the front wheels and pull the wheels off of the shove hubs.
6. Change to the front Chauffeur's side rotate and establish the docent pin bolts on the back of the brake caliper. The caliper has a lower and an upper criterion pin bolt. Remove the bolts from the back of the caliper with the ratchet and a 1/2-inch socket.
7. Set the access gap on the side of the brake caliper. Slide a pry bar into the access gap between the brake rotor and the outer brake pad. Pry against the outer brake pad until the cylinder retracts into the caliper Sufficiently to loosen the caliper from the rotor. Remove the pry bar.
8. Pull the brake caliper off of the brake rotor by labourer. Provided the rotor is stuck, pry the top and backside of the caliper with the pry bar. Hang the brake caliper on of the steering components last the trundle hub plate with a quantity of rope.
9. Pull the outer pad away of the retaining clip inside of the caliper. Then position a 6-inch C-clamp into the caliper with the adaption bolt facing the outer brake pad. Turn the C-clamp ear clockwise to push the outer brake pad against the caliper cylinder. When the cylinder is fully retracted into the caliper, unscrew and remove the C-clamp. Then pull the outer brake pad outside of the other retaining clip.
10. Observe the brake rotor for wear and grooves. Provided the rotor has minimal wear or grooves, proceeds the rotor to a apparatus shop or an Car repair effortlessness To possess the rotor turned. Whether the rotor has Exorbitant wear or grooves, alternate the brake rotor.
11. Position the two cutting edge brake pads into both retaining clips inside of the caliper. Remove the rope from the caliper and slide the caliper back over the side of the rotor. Secure the caliper with the two bird dog pin bolts and tighten it with the ratchet and socket. Position the circle back onto the hub along with the lug nuts. Tighten the lug nuts with the tire thing until the shove turns.
12. Motion to the other front circle and repeat the twin steps for replacing the brake pads. After the brake pads hold been replaced, jack your 2000 Pontiac Grand Am back up and slide the stands away from the backside of the frame rails. Then lower the Grand Am and remove the floor jack.
13. Agape the hood and remove the brake fluid reservoir lid. Squirt the brake fluid back into the reservoir from the syringe and place the lid back on. Then accelerated the hood.
14. Eccentric person your 2000 Pontiac Grand Am and pump the brake pedal in and away five or six times to properly seat the brake pads to the brake rotors. Then impel the Grand Am on all sides of to test the brake pads.
