Tuesday, September 8, 2015

Replace A Ford Energy Window Motor

Whether your Ford vehicle has potential windows, Everyone has a meager Engine that operates the regulator that contains and controls the window. Whether the competency window controls aren't working and you comprehend the poser isn't electrical, the Engine might longing replacing. Consult with your Car mechanic or parts store and accomplish persuaded you bias a replacement Engine for your particular Ford vehicle. Then, you must remove the window regulator from inside the door to replace the motor.


Instructions


1. Lower the window to the bottom so you can easily access it and the regulator. Disconnect the negative battery cable once the window is down.


2. Open the door and remove the trim panel. Remove all the screws, starting at the door handle bezel, and slide the panel off of its retainers. Disconnect all electrical connectors on the panel. Peel away the plastic water shield and disconnect the window motor assembly's harness.


3. Disconnect the bolts holding the window to the regulator and slide the glass out of it. If the vehicle has an upper window frame (like an F150 or other truck), push the glass up and tape it to the frame. If there is no upper frame (like on a Mustang), remove the glass completely.


4. Place the regulator back into the door (you might need to twist it into place) and reapply the bolts holding it to the door. Push the glass back down into the door and fasten it back on the regulator.7.


5. WIggle the new motor into place on the regulator within the cable housing. Put the fastener into its proper location and replace the front side bolts for the motor.


6. Remove the bolts fastening the regulator to the door and disconnect its electrical connectors. Fold the regulator assembly's sides together and slip it out of the lower hole in the door frame. Remove the front side bolts on the motor and wiggle it off of the cable housing. Make sure the cable gear stays in the housing.


Attach the plastic water shield back on the door and install the trim panel. Test the motor and window operation by raising and lowering the window.