Having an overhead DVD player installed in your vehicle allows you to entertain your backseat passengers while on the course of action. Installing a DVD player in a Pontiac Montana is not as compact as it sounds. The facilitate bracket for the DVD player uses the mark and wiring from the overhead dome glowing, so there is no want to chop any holes in the ceiling or add any wiring to the vehicle. Once the relieve bracket is in field, it's due a incident of sliding the DVD player on the bracket and enjoying it.
Instructions
Habitat the support bracket on the ceiling over the gap and hint encompassing it with a carpenter's cutting edge to chop and remove the surrounding headliner. Remove the bed bracket, pull the wires away from the ceiling gap, slide the wires terminated the opening in the bracket and lay the bracket back up on the ceiling where the headliner has been removed. Removing the headliner under the bracket reduces vibration in the DVD player.3.
1. Pry under the dome light with a flathead screwdriver to assemble period for your fingers so that you can remove the dome light with your hands. Remove the dome flashing, unplug the wire harness from the back of the dome glowing and tuck the wires up into the ceiling gap.2.
Drill a hole through each corner of the support bracket into the ceiling by using a drill with a machine tap drill bit. Insert the mounting screws through each hole and tighten them with a Phillips screwdriver. Plug the wire harness into the DVD player. Slide the DVD player onto the bracket and push it back until it locks securely in place.
