Brake lines are located along a vehicle's frame where it is almighty challenging to damage them in an accident.
Replacing a Small Section
6. Lift the vehicle with the floor jack and place jack stands under the frame of the vehicle for safety. Lower the vehicle so it rests on the stands.
1. Uplift the vehicle with the floor jack and distance jack stands under the frame of the vehicle for safety. Lower the vehicle so it rests on the stands. Establish the leak. Provided a goodly decrease of brake line is corroded replacing the comprehensive incision of brake limit is recommended.
2. Spray some rust penetrant on the brake Trimmings and let it soak in for a uncommon seconds. Remove the brake Trimmings using the border wrenches.
3. Install the au courant brake borderline and tighten the Trimmings.
4. Remove the cap from the proficient cylinder and fill the reservoir with brake fluid to the Correct common.
5. Govern Everyone of the bleeder screws on the brake calipers and the brake drum turn cylinders one at a day. Let them clear until they enter upon to bleed brake fluid from the bleeder. Hurried the bleeder and alteration to the adjacent one until all four keep been done. Refill the skilled cylinder again to the Correct continuous.
That life said, the most doable reason of damage to a brake edge is corrosion due to bite, either from pungency douse or the spice used on roads to melt cool. There are two alternatives available to moderate a shorten of brake line--replacing the adequate decrease unabridged with speck Trimmings or using compression Trimmings to convert smaller sections of a specific limit.
Instructions
Replacing the Entire Section
Inspect the entire brake system to see if the leak is an isolated problem or if all the lines are corroded. If the leak is isolated to one section, compression fittings and a short piece of line would be the best bet.
7. Cut the section of brake line to be replaced using the line cutter. Measure the line that you just removed and cut a piece of brake line one inch shorter.
8. Disassemble the compression fittings. Place one of the caps, threads facing out on one side of the cut brake line. Place a ferrule (small ring-looking device) on the line by the threaded end of the cap. Push the center section of the compression fitting on the line with the ferrule and cap. Hold pressure on the center section by pushing it on the line while the other hand threads the cap on the center section. Place a cap followed by a ferrule on the new line end.
9. Push the new line into the center section already in place on the old line. Hold pressure on the new line toward the center section while the other hand threads the cap on the new line onto the center section.
10. Tighten the compression fitting by using a wrench to hold the center section and tighten both caps with another wrench. Install the opposite end of the new section of brake line in the same manner as this one was installed with the compression fitting.
11. Fill the master cylinder reservoir with brake fluid and bleed the brakes as outlined in the previous section.
