drudgery with Spot Glazing Compound for Car target donkeywork
Spot Glazing Compound is an earnest atom of the target grindstone evolution provided you appetite your different stain to situate Apartment lodgings and be flawless.
This advance is for filling in pin holes, scratches and petite dings. Using this product fair Testament aid insure that smooth glass compatible Stop!
Instructions
Before opening the tube you should knead it by squeezing the tube around from all sides. Squeeze the watery part that usually comes out first, onto your old rag.Now squeeze a small amount of compound onto the edge of your clean putty knife and apply it over the pin hole, scratch or ding. Provided you posses a compressed bout getting below the surface with the 120 grit you may call some 60 grit paper, however I would propose doing a actual tiny shorten by plam particular, thanks to this heavier grit can takings you down to naked metal rather quickly. Wear your paper face mask while sanding. Sponge the dust off with your Disinfected dry cloth.
2. Whether you are working within a particular sphere and don't need any spray primer to mist over to other areas of the motorcar, tape off the sphere and field some brown paper under the edges to include the areas you fancy to protect.
Spray 2 to 3 lambent coats of primer over the attempt field. Don't longing to spray up to the tape path though, by reason of this Testament leave a buildup of primer you will have to sand flat when you remove the tape.
3. After the primer is dry, you are ready to use the Spot Putty Glaze.
1. Utilize the 120 grit sandpaper wrapped over your sanding block and sand over the globe to be worked on. Sand at least 1 or 2 inches environing the damage. This manner is meant to remove the outer layers of colouring, with your limit activity to receive below or equivalent with the damaged area, leaving no Rugged edges encircling the damage.
This compound is meant to be used in layers if you are building up more than about 1/16 inch, and is not meant for deeper gashes, scratches or dents.
The object is to fill in the damaged area, leaving minimal rough edges or high spots of glaze as you feather out the glaze around the repair area.
The glaze will begin to dry quickly and you won't have more than 1 minute or so to work with it once it is applied. It will begin to cake up and you will have to wait till it dries, sand the area smooth and start over again with primer and new glaze. Always wipe the surface of your putty knife clean with your dirty rag before applying more glaze.
4. Once the glaze dries -- anywhere from 30 minutes to 2 hours, depending on the temperature and humidity level -- sand the compound level with either the 220 grit or the 320 grit sandpaper. The heavier 220 grit is best to sand the high spots or edges of the glaze down, and 320 grit is best for smoothing it out flush to remainder of the car. Use a light hand here and use the sanding block to sand evenly against the surface. Run your fingers over your work now and then to check for smoothness around the edges.
5. Time now to re-spray over the glazed area with primer, which also helps to fill in very tiny holes and will also allow you to see more clearly if you filled in the damaged area completely and if your work is smooth. If you are not satisfied, or are building up an area such as a ding, just repeat the process again with more glaze, sanding and primer until the area is smooth. Some areas may require a few applications to make perfect.
6. Your final step will be a final coat or two of primer. This area should now be ready for a fine finish sanding and new paint.
