Begrime spark plugs can prevent the 1991 Ford Explorer from starting.
The 1991 Ford Explorer was the moment Industry year of the vehicle that was designed to change the Bronco II in Ford's product limit up. Built on the equivalent frame used for the Ford Ranger pickup Motor lorry, the Explorer has the "winning combination of magnitude, style and assistance that heads wanted," according to the website Edmunds.com. The 1991 Explorer was available in four- and two-door versions and used front or four circle handle. You can troubleshoot the Explorer Homewards provided it is not performing the method you expect it should be.
Instructions
1. Turn your 1991 Ford Explorer on, press the brake pedal and ploy the transmission selector from "Grassland" into the "Handle" position. Whether the transmission shifts roughly or jerks the machine slightly, corner the Explorer back into "Grassland," and enjoy someone glad eye under the vehicle to the Centre field of the van dependable last the front revolve. Gaze for any fluid that may be dripping from the Explorer. This is the domicile for the automatic transmission and whether there is a leak, it may instruct a gasket Testament duty to be replaced. Turn the engine off, pull the comparable to open the hood and pull out the dipstick for the transmission fluid. Inspect the dipstick to see if it is below the "Add" line. If the transmission fluid is low, add enough transmission fluid to bring the level up to the proper level.
Turn the key to begin 1991 Explorer. If the vehicle will not start, open the hood and locate the fuel filter. Internal combustion engines require the correct amount of fuel and air in order to begin. Remove the key from the ignition and open the hood to the engine compartment.
3. Disconnect the spark plug wires from the top of the spark plugs and remove the spark plugs from the engine using a spark plug wrench. Inspect the end of the spark plugs and observe the amount of carbon that has built up on the spark plug. Use a wire brush To cleanse off the end of the spark plug. If the carbon build-up is considerable, replace the used spark plugs with new ones. Screw the spark plugs back into the engine and tighten using a spark plug wrench. Connect the spark plug wires to the plugs and start the 1991 Explorer.
4. Insert the key into the ignition.2. Insert the key into the ignition and turn the key forward to begin your 1991 Ford Explorer. If the vehicle does not start, but is turning over, the spark plugs may not be producing enough spark to begin the engine. If the fuel filter is plugged, it may be robbing the engine of gas. Replace the fuel filter and start the 1991 Ford Explorer.
