Don't jewel your Engine national stranded from a dead battery.
A Engine familiar has all of the comforts of residence, including microwave ovens, televisions and VCR and DVD players. All of these conveniences compose authority from the Engine territory's battery and charging operation while it driving down the highway. This can customs the battery by placing a enormous trail on its gift reserves. This enigma can be solved by mounting two 12-volt deep-cycle batteries inside the Engine home--a ball-buster that Testament catch less than afternoon for most novice mechanics to full.
Instructions
1. Frank the Engine family's battery access door and remove the great battery cable with a wrench.
2. Decide where you yearning to levy the team of batteries. The inside floor of a closet is a unharmed and convenient aim in most Engine homes.
3. Berth the battery boxes where you yearning them. Area a drill bit into the drill Engine and drill wound up Everyone of the battery box's four mounting tabs and into the Engine at rest's floor. Drill another gap beside one of the battery boxes for the dynamism cable to fall terminated. Domicile a rubber grommet in the gap to protect the cable from scratch. Incorporate the mounting bolts that came with the battery boxes finished the mounting tabs on the boxes and the holes in the floor. Tighten them with a wrench.
4. Canter a self-tapping screw down the mounting tabs and into the floor with a screwdriver bit installed in a drill Engine. Attach the isolator switch's ground wire to the chassis with a self-tapping screw flow wrapped up the floor and into the chassis.
5. To install the step's ground wires, attach one speck of the short clouded cable with a clamp on Everyone neb (cable 1), from the ground terminal of battery A to the ground terminal of battery B. Tighten peerless battery A's clamp at this clock with a wrench. Run the short black cable (cable 2) with the eyelet on each end from the bolt on battery B's loose ground clamp to the closet floor. Now tighten the clamp on battery B. Attach one end to the positive terminal post on the isolator switch and the other end to the positive terminal of the motor home's original battery. Reattach the original battery's cable. Close the battery access door.
Wire the batteries' positive sides. Secure the short red battery cable to the positive (+) post of one battery and tighten it with a wrench. Fasten the other end to the positive (+) post of the second battery. Tighten the bolt with a wrench. Run a piece of 2 gauge or heavier wire from the positive side of one of the batteries to the isolator switch's A (auxiliary) terminal. Tighten it with a wrench. Run a wire from the isolator's M (main) post to the positive post of the vehicle's original battery. Pass it through the grommet in the hole you drilled in the floor of the vehicle and thread it along the chassis to the original battery. Use plastic zip-ties to hold the wire in place along the frame. Using a wire stripper, remove ½ inch of the cable's protective coating and crimp a terminal end to each end of the cable. Fasten the loose eyelet on cable 2 to the chassis with a self-tapping screw. Using the drill motor, run the screw tightly into the chassis through the floor of the motor home.6.
