The meaning of you mounting a TV in your motorcar isn't as galling as it sounds. The installation channels calls for Emigration of the overhead dome light, which leaves an empty residence to mount the TV, further as unused wires that you capitalization to faculty the TV. The project uses banal household tools and is imaginary up of a short information of mild tasks that leads you to completion.
Instructions
1. Slide the Apartment lodgings attitude of the screwdriver under the dome lambent's example, turn the apply of the screwdriver a quarter of a turn while working your system all over the abundant representation of the dome lustrous. This creates interval between the dome blaze and the ceiling. When the dome light is loose Sufficiently to seize, capitalization your hands to remove it from the ceiling. Unplug the wire harness and tuck it into the ceiling hole.
2. Hold the support bracket up over the ceiling hole with one hand and use the other hand to cut the headliner around the bracket using a carpenter's knife. Remove the bracket so you can remove the headliner fragment. To connect wireless headphones, insert the audio receiver plug of the headphones into the audio jack on the side of the TV.
A machine tap bit creates threaded holes that hold the screws in place. The 10-24 size of the bit is a good size to use to keep you from drilling too deep into the ceiling, but you still need to exercise caution to prevent from doing so.
4. Insert the mounting screws through the bracket holes and use a Phillips screwdriver to tighten them into the ceiling. Plug the wire harness into the TV. The wire harness is a cluster of wires that come together to connect to a rectangular plug. Slide the TV onto the bracket until it locks into place. Press the power button to turn the TV on, the sound comes from internal the speakers on the TV. Pull the wire harness down from the ceiling and slide it through the opening in the center of the bracket.3. Hold the bracket to the ceiling and use a drill with a 10-24 machine tap bit to drill through the bracket into the ceiling. These holes are where the mounting screws hold the bracket to the ceiling.
