The rocker panels on your Chevy are trim pieces that escape along the backside of your door. The rocker panels on your Chevy predispose damaged easily considering they are so low to the ground. Provided this happens you can alter them with distinct panels. Replacement rocker panels can be purchased from your Chevy dealership. Chrome after-market rocker panels are and an possibility available nailed down thing shops. It takes approximately two hours to modify the rocker arms on your Chevy. On the contrary, the duty goes faster provided you chalk up an assistant to nourishment you.
Instructions
1. Jack up the front boundary of your Chevy and put jack stands under your front frame to backing the vehicle while you functioning on it.
2. Bargain the screws inside the front turn chipper that your rocker panel attaches to. Remove these screws with a Phillips screwdriver.
3.7. Slide the new rocker panel, with your assistant, back along the bottom of your door.8. Have your assistant hold the new rocker panel in place as you insert the fastening screws and tighten them inside your front and rear wheel wells.
Clean the area where your rocker panel sat with a cloth and finger nail polish remover to receive up any pieces of adhesive from the old rocker panel's double-sided tape. Use a plastic putty knife to remove hard-to-get pieces if necessary.
6. Apply double-sided automotive tape to the back side of your new rocker panel.
Asset and remove the fastener screws on the inside of the rear turn flourishing while your assistant holds the rocker panel in situate.4. Push on the rocker panel, towards the front of your Chevy, and the rocker panel should slide and pop off.5.
9. Repeat these steps to remove and install a new rocker panel on the other side of your Chevy.
