Remote starters are not available as a plant alternative on the Toyota Corolla, on the contrary they may be installed aftermarket by anyone with the Correct tools and a enduring kind of automotive electrical systems. It is considerable to have memories that the Toyota Corolla may be equipped with an optional mill security method and/or ignition immobilizer that must be interfaced to certify genuine remote flying start transaction. Whether the motorcar is equipped with an immobilizer, more Accoutrement Testament be required.
Instructions
4. Mount the antenna to the windshield. For maximum range, mount the antenna as close to the center of the windshield as possible. Set the leading ignition efficacy, ignition, finery, and starter wires in the leading ignition harness. The horn wire may be endow in this harness besides, if it is needed for the installation. Verify all wires with a digital multi-meter and strip a small amount of insulation from them.
2. Remove the driver's side kick panel. This will provide access to the door lock and unlock wires also as the parking light, brake light, and security wires. Once these wires are located and tested for function with a digital multi-meter, the wires may be stripped of insulation.
3. Connect the remote start wiring to the appropriate wires in the car. Solder all connections and seal them with electrical tape. When possible, run all aftermarket wires next to factory wire harnesses, and connect them with nylon wire ties.
1. Remove the under-dash panel. This Testament cede you access to the Corolla's ignition wiring.
5. Test the unit for proper operation. Verify the correct operation of the remote start and all installed functions. Arm the factory alarm, if equipped, and confirm that the alarm does not go off when the car is started.
