Before attempting to transform the ignition switch on a Ford, the air bag must be deactivated to prevent unforeseen discharge of the operation. The ignition principal tumbler and the ignition switch should never be removed at the corresponding continuance or damage to the line may arrangement. It is further big to specify to the parts retailer that the electrical angle of the ignition switch is existence replaced. Many times the parts store personel Testament bungle the ignition main tumbler for the ignition switch.
Disconnect the ignition switch lower harness connector. This is just below the steering column or can be seen at the opposite end of the ignition harness.4. Install the new ignition switch by locating the switch so the tabs line up and pushing it on the tumbler.
2. Remove the lower cover on the steering column behind the steering wheel using the Phillips screwdriver to remove the three screws. Press the two tabs on the side of the ignition switch and pull it straight off.
3.
Instructions
1. Disconnect the negative cable on the battery with the 8-millimeter wrench and allow 15 minutes for the circuits to go to sleep before beginning. This will disable the SRS, or airbags.Plug in the lower portion of the electrical pigtail or harness connector.
5. Reinstall the lower portion of the steering column cover. Reconnect the negative cable on the battery.
