The Toyota Previa muffler is not a packed one to alter. The hardest division might be locating the correctly muffler for the year and imitation Previa you hold. In other passage, if it's a DX model Previa or an LE mould Previa. Choosing the Trade-mark of muffler may be another remonstrance and then finding the availability of one. Toyota Testament carry one for approximately $350 plus shipping. On the other hand you can treasure trove one in the aftermarket nature for less than half of that with the corresponding bleeding heart of warranty and shipped to you honest as quickly. Bosal is a skilled import aftermarket exhaust method manufacturer and you can pay for or composition them finished many regional parts stores or catch them online. Due build decided you own all the info approximately our Previa before you act.
Instructions
1. Lift the Previa all the means up on a automobile lift.
2. Set the flange connexion of the muffler inlet drainpipe decent forward of the rear axle.
3. Levy on cutting glasses and gloves and glowing the torch. Abbreviate the two bolts on the muffler side of the flange connexion until they are melted or shorten below the flange itself. Turn off the torch.
4. Strike the muffler side of the flange with a hammer to seperate the two flanges. If you have to, use the punch and hammer to knock out the cut bolts through the other flange. Once the separation of the flanges are complete, switch over to the safety glasses so you can see better.
5. Remove the muffler hangers (front and rear) from the rubber hangers on the frame of the Previa. Discard the old muffler.
6. Clean any remnants of the old gasket off of the pipe flange where you cut the muffler from using the gasket scraper.
7. Install the new muffler in the same manner you removed the old one. Place the rubber hangers on the frame onto the muffler hangers to hold it in place for you.9. Secure the bolt head in place with the box wrench and tighten the nut with the gun and socket. Tighten one side snug. Then bring in the other side.
The rear axle will hold the inlet pipe in place.8. Insert the new gasket and connect the new muffler flange to the pipe flange. Connect with the 10 millimeter hardware placing the flat washer on the bolt head side of the flange and the lock washer and nut on the other side. Do not tighten one side securely first and then the other, or you may kink the gasket.
10. Lower the Previa and start it up to check for any leaks at the flange connection.
