Depiciton cars can be a tedious activity, exclusively when it comes to stripping the dye from the vehicle. Happily, there are many at variance methods to remove debilitated paint from cars, and here we'll consider a scarce of them.
Instructions
Media Blasting
1. Remove all glass and rubber from the vehicle, as it Testament excite damaged.
2. Place on a protective suit, preferably one with a respirator. Depending on the media used, it can invest in genuine dusty and poisonous when media blasting, and you don't necessity to breath that baggage in.
3. Choose a media. You can bag sand, glass Ambition or much baking soda. Pull the trigger on the tool and slowly move across the body, watching the paint disappear as you go. Keep consistent and move about a foot a minute or so. Keep a solid pattern to make the process easier.
Manual Stripping
4. In a well-ventilated world, applicability the media blasting stuff to remove the tint. Don't spend further even hour in one existence owing to it Testament start to heat up the panel and warp the steel. Just take your time and work the media across the body. Everyone one has its own properties, so dig up which works boon for your apply and invest in that media. Baking soda is colossal for colouring Emigration, on the contrary not rust, and it's further bio-degradable. Sand and glass are positive for emulsion and rust, nevertheless glass has also consistent sizing, giving you and predictable results.
5. Remove all of the glass and rubber from the vehicle.
6. Use a DA sander to rough up the paint. Use an 80-grit sandpaper and work your way around the vehicle. 80-grit is usually strong enough to take the vehicle down to bare metal. Use sanding blocks in tighter areas to ensure that all the paint is gone.
7. Go over the vehicle again with 120-grit sandpaper. This is will stop the deep scratches that the 80-grit sandpaper put into the metal from showing up in the final paint job. You can also go over it yet again with 200-grit to receive a better finish.
Chemical Stripping
8. Remove all of the glass and rubber from the vehicle. Then put on the rubber gloves and make sure the car is in a well-ventilated area.
9. Carefully pour a small amount of aircraft stripper over the surface you want to remove the paint from. Kleen-Strip is a great brand to use because it's simple to apply and easy to find.
10. Let the stripper sit for a few minutes to work. It will cause the paint to lift and look like it has bubbles. Once it does, use a plastic squeegee or putty knife to push the old paint off the body.
11. Repeat as necessary. This may take a few applications to receive perfect, but once it's done, you'll have a bare-metal finish. Use 200-grit sandpaper to rough up the surface before applying an epoxy primer.
