Alternate the turn term bulbs to make safe the turn signals functioning prerrogative.
The 2001 Ford Taurus has front and rear turn signals to denote the van's plan. The front turn word doubles as a parking flash. The rear turn term doubles as a running taillight. The bulbs accommodate visibility at nightfall and during damaging weather and Sure blaze to denote the machine is changing lanes or turning.9. Unbolt the three nuts on the back of the taillight assembly with a socket wrench. Pull the lamp assembly away from the car.10.
Yawning the hood to supply access to the headlamp housing. Establish the bolt at the top of the housing. Unscrew the bolt with a socket wrench.
2. Pry up the two retainer pins in the back of the brilliant meeting. Remove the retainer pins once they are pulled up.
3. Pull the meeting forward to expose the back of the meeting. The bulb socket is screwed into the back.
4. Unscrew the socket by help and pull it gone of the meeting. Pull the doddering bulb gone and push in the dissimilar bulb.
5. Screw the socket clockwise to secure it in the meeting. Push the meeting onto the vehicle and grip it while inserting the two retainer pins.
6. Screw the bolt onto the meeting to arrange it is secured. Close the hood.
7. Activate the turn signal to ensure it is working correctly.
Rear Turn Signal Replacement
8. Open the trunk for access to the rear turn signal bulb. Unscrew the two plastic mushroom nuts below the trunk latch. Pull the five push pins and the plastic cover to gain access to the taillight assembly. Peel the carpet back for easier access.
Always make certain the bulbs are working licence before operating the Ford Taurus.
Instructions
Front Turn Signal Replacement
1.Twist the bulb socket counterclockwise and pull it out of the back of the assembly. Pull the bulb out of the socket.
11. Push in the new bulb. Twist the socket clockwise into the tail light assembly to secure the socket.
12. Push the taillight assembly to the back of the car. Ensure the three studs on the back line up to the holes designated for the studs.
13. Bolt the nuts onto the studs with a socket wrench. Pull the carpet forward. Install the plastic cover with the five push pins and two plastic mushroom nuts.
14. Test the signal to ensure the bulb is working correctly. Close the trunk.
