Remove a Machine Door Panel From a Jeep Cherokee
Access to the inner workings of the doors on your Jeep Cherokee requires Emigration of the inner door panels. If the front or rear door, the panels come off using the corresponding basic evolution. Be careful that you determine not scratch the surface of the panel as you commission. Once the panel is off, store it in a protected community until you are ready to install it back on the door. This Testament make safe no damage occurs to the panel while it is off the Jeep.
Instructions
1. Plain the door and roll the window all the design down. Remove the window Eccentric person shaft with a crank removal baggage. Whether you cause not keep a crank removal tool, you can purchase one at most Car parts stores.
3. Act to the backside of the panel and using a Apartment lodgings putty kukri or trim stick, pop the panel elsewhere from the door along the backside edge. The plastic pins that hold the door may pop out, but be prepared that they often break no matter how gentle you are with them.
2. Establish the screws in the upper door panel. There are three screws, one in the top of the door use, one in the trim under the door fastening Proceeds and one on the front of the armrest. Remove all three of these screws with a Phillips screwdriver.
4. Pull the panel out slightly and lift it up to remove it from the window track at the top of the door. Disconnect the rod attached to the handle on the back of the door panel.
5. Disconnect the wiring harness connectors for the power door locks by pushing the locking tab on the connector and pulling it free. Remove the panel from the Jeep.
