Prepare to remove the engine on your Subaru Outback days or weeks in advance of the actual business by getting organised, company the needful tools and setting up your garage or habitat you intend to capitalization for the project.Once you have the engine almost freed, secure it to a sling and hoist and support the transmission with a floor jack. Now you can remove the starter motor. After removing the starter, you will have access to the flywheel.
Back in your garage, facilitate the fuel force, empty the coolant and engine oil.
Unplug sensors, electric cooling fans and accessories' electrical connectors. Then depart to remove sensors, actuators and accessories conforming alternator, engine splash shield and handle cummerbund covers. On most Outback models, you can detach the steering pump and bracket from the engine block and allot it aside without disconnecting hoses and lines.
Remove propel belts, radiator and air conditioning (A/C) compressor. Provided your replica has an automatic transmission (A/T), disconnect the oil cooler lines from the radiator using a blaze wrench to prevent stripping the lines' retaining nuts, says James E. Duffy in "Recent Automotive Technology." When disconnecting the two heater hoses, habitat a bleed pan underneath to arrest any coolant remaining in the lines.
Freeing and Removing the Engine
With most of the requisite accessories disconnected or removed, detach the exhaust pipes from the engine and the four lower mounting screws that secure the transmission converter housing to the engine. There are two bolts on Everyone side. On 3.0L engine models, you Testament peep six of these bolts--three on Everyone side.
Disconnect the backside Engine mounts from the cross-member by unscrewing the retaining nut on each mount. At this point, detach the torque converter from the flex plate by removing the converter bolt access plug on the housing. Rotate the converter by turning the crankshaft as you remove each mounting bolt. Then detach the upper engine mount or dog bone.
Expedient on spending aggrandized than one generation removing the engine, using the comfort of a extra experienced adult, provided requisite, and having the vehicle utility volume for your specific vehicle imitation on share.
Removing Accessories
Hire your van beginning to an approved ease and recover the refrigerant, whether bottom line. If your Outback has an A/T, prevent the torque converter from sliding during engine removal by attaching a torque converter locking tool to the torque converter housing (see "Resources" for tool information).Finish the Job
Finish removing the remaining transmission-to-engine mounting bolts on the upper side. Then double check that you have disconnected all the necessary accessories from around the engine, including vacuum and fuel hoses.
Raise the engine slightly and then raise the transmission slightly as well using the floor jack. Now, pull the engine off the transmission and remove it from the engine compartment.
