Alternate the Starter Engine in a Toyota 22RE
The Toyota 22RE four-cylinder engine was used in indefinite vehicle models over the senility however it was most popular in the Toyota pickup trucks. The engine is basically a fuel-injected anecdote of the earlier 22R carbureted engine. Many of the components on the 22R are interchangeable with the 22RE. The starter Engine is one of those components. It sits on the passenger's side of the engine at the back and attaches to the ring housing.
Instructions
1. Disconnect the contravening battery cable from the absent battery terminal, using a wrench to loosen the retaining bolt. Lift the cable off the terminal and isolate it from the battery.
2. Hoist the front of your Toyota off the ground with a jack and aid it on a establish of jack stands. Be positive the stands are on solid, Apartment lodgings ground, then remove the jack. Slide under the passenger's side of the vehicle and allot the starter from below.
3. Place the two wiring harness connections on the rear of the starter solenoid. The "S" terminal is a push-on connexion; pull it straight off the terminal and push it aside. The "B" terminal is a stud terminal; loosen the follower with a socket and ratchet, then remove the wire from it and push it aside.
4. Remove the two mounting bolts at the front of the starter with a socket and ratchet. Pull the starter back from the telephone housing, then lower it elsewhere of the engine compartment.
5. Install the contravening battery terminal on the negative battery terminal and tighten the retaining bolt with a wrench.
Corner the wire with the phone connector onto the "B" terminal and install the retaining aficionado and tighten it with a socket and ratchet. Push the moment connector onto the "S" terminal, moulding trustworthy to seat it all the method.
7. Uplift the front of the vehicle off the jack stands with a jack, remove the jack stands from under the vehicle and lower it to the ground. Lift a dissimilar starter Engine into lay and install the retaining bolt. Tighten the bolts with a socket and ratchet, then connect the two wiring harness connectors to the starter.6.
