Tuesday, June 30, 2015

Trobleshoot and fix The Environment Conditioning Inside A Chevrolet Cobalt

Determine to diagnose universal problems in your vehicle and you may save a quantity of method on costly repairs. Trial the temperature controls to bring about persuaded they endure conscientious. Provided they are not working the duplicate as they did before the air conditioning went gone, then it is as no sweat as a fuse doubt.2.



Air conditioning problems are all told colloquial and can be authentic no problem to set or may be extensive issues. Troubleshoot your air conditioning problems in a Chevy Cobalt.

Instructions

1.


Boast the fuse box in a Chevy Cobalt on the passenger side of the centre console near the floor. The fuse that controls the air conditioning is unit 10. Exchange it with one of the replacement fuses available, which are numbers 2 on ice 5.


3. Turn the motorcar on and adjust the air from low to high-reaching and back down again. Listen for the blower Engine. The cacophony should development when turned higher and shorten when turned lower. The blower motor will be a black cylinder-shape with a white plastic bowl-like piece on top.


4. Unplug the electrical connector, remove the stakes holding into place with a chisel, remove the nuts and take it out to examine it.


5. Stare at the compressor if all else fails. This is tricky to do, since the car must be raised to Stare at the compressor in a Chevy Cobalt. It is on the right side near the fender. It is a silver-colored cylinder shape with multiple extensions from it.


6. Look at it while the engine is off. A common problem is just requiring a new belt. Make sure all of the connectors are intact, and there is no rust.


7. Examine the control module in a Chevy Cobalt if the dials and switches on the dashboard are working correctly but have no effect on the air conditioning. First disconnect the battery. Drain the coolant, disconnect the inlet and outlet hoses from the heater core, disconnect the blower motor and remove the instrument panel trim. Raise the center floor outlet duct; rotate the center floor outlet duct forward at the same time pull down on it to remove it.