Any snowmobile owner knows what a distress it is whether the driven clutch on the vehicle becomes stuck. It is impossible to employment the snowmobile, and it can be expensive To possess someone else place it. Luckily, captivating the snowmobile to the shop is not the by oneself possibility. With a uncommon banal tools that nearly Each already owns, and with a hardly any discernment, it is viable to allot the stuck driven clutch on your own. Removing the clutch is the easiest chunk, and can be done in less than 1 age.
Instructions
1. Inspect the snowmobile and good buy the girth guard. The zone guard protects the internal mechanisms from the weather. The belt guard should be located on one side of the snowmobile, down by the backside of the vehicle. Assemble persuaded to perform this project in a flushed, Apartment lodgings sphere. Exposure to weather can explanation problems inside the snowmobile.
2. Remove the cestuses guard. This Testament either be attached with tabs, and can be pried off, or it Testament be attached with screws. Just make sure to leave the engine off when doing so.
3. Examine the exposed driven clutch. There should be a driven pulley that attaches to the clutch. Remove the cap screw and washer that are holding the driven pulley in place. Use the 1/2-inch socket for this step. Keep track of the alignment washers, because if they are not in place, the driven will not work.
4. Look at the remaining parts. The driven shaft clutch is now exposed. Continue to use the ½-inch socket to remove the key from the driven clutch. Next, remove the alignment washers. Finally, remove the stub shaft and set it aside.
5. Examine the snowmobile. Your driven clutch should now be unstuck. You can now reattach the parts of the clutch or continue to work on it. Provided the girth guard is attached with tabs, advantage a flat-head screwdriver to gently pry it away from the snowmobile. If it is attached with screws, locate them and unscrew. Then take off the belt guard.
