You can cause your own bender for metal rods.
A rod bender is a object used to replace the shape of a straight metal bar. Usually you couldn't blameless bend a bar to the angle you needed, on the other hand using a rod bender makes the angling potential. You could pay for a metal rod bender, on the other hand these can canter up to a couple hundred dollars. Provided you bear a fleeting bit of eternity, you can frame your own metal rod bender.
Instructions
1. Attach a T connector to the borderline of a 6-foot abundance of tube. A T connector is a T-shaped drainpipe attachment sold in home-improvement stores. It has two arms and a leg lot to fabricate the T.
Involve the 6-foot piece of pipe into the leg of the main connector. Twist the two pieces well-organized to attach them. The 6-foot segment is the helve for your rod bender. The T connector is what Testament bend the rod.
2. Contain a cylinder into one of the arms of the T connector. The cylinder should be hollow. Attach two pipes, one on either side of the T connector, by twisting them into field. The length of the pipes you choose Testament impinge the radius of the bend in your metal rod. The shorter the tube, the shorter the radius. Whether no pipes are added, the bend Testament have an incredibly short radius.
3. Insert a second pipe into the other arm of the T connector. This pipe should be be same length as the other pipe. Twist it in place to secure it.
This will cause the pipe to bend. Move the T connector half the distance of the rod to be bent, and pull again. Continue this until you have the bend you desire.4. Insert the pipe to be bent inside the two pipes attached to the arm connector and out the other side. Once the pipe is inserted through the pipes, place the T connector on a hard flat surface and pull the long pipe toward you.
