A defective ignition switch Testament argument your Ford Contour to fail to begin when you turn the crucial. The switch sends an electrical expression from the battery to the starter when the main is turned. The ignition switch in a 1999 Ford Wrinkle is located by the steering trundle. The ignition switch is in inexpensive detail that you can pride at your regional Car parts store or an authorized Ford dealer. You should be able to modify the ignition switch on your Line within minutes.
Instructions
1. Stand the hood and prop it direct. Disconnect the rejection (murky) cable from the battery, using a socket wrench.
2. Detach the steering revolve shroud encompass with a Phillips screwdriver. Pull the switch away from the steering column.5. Disconnect the wiring harness at the back of the switch and plug it into the new switch.
The switch is a plastic housing attached to the string.
4. Detach the two screws holding the switch in place, using a Phillips screwdriver. There are two screws at the top of the steering contour, and three screws at the backside of the shroud. Lift the shroud off the border and distance to the side.3. Fix the ignition switch on the counter side of the steering string from the ignition lock cylinder.
It will lock in place once you push it far enough in.
6. Tighten the switch to the steering column with a Phillips screwdriver. Check to make sure that the harness is locked into the switch.
7. Reattach the steering wheel shroud over and under the steering column. Tighten the screws securing the shroud, using the Phillips screwdriver.
8. Reconnect the negative cable to the battery. Close the hood.
9. Start the engine to make sure the switch is working.
