Tuesday, November 11, 2014

Alter The Ignition Turn On An Alero 2002

Disable the airbag development before replacing the ignition switch


Interchange the ignition switch in a 2002 Oldsmobile Alero after a widespread trouble-shooting session to eliminate issues with voltage, shorts, defective justification and unlatched circuits. Don't forget to turn off the theftlock process on the radio before you disconnect the battery. Your album explains enter the true regulation to prevent permanently disabling the radio.


Instructions


Remove the Ignition Switch


1. Disconnect the adverse battery cable with a socket or box wrench. Pull the airbag fuse from the Chauffeur's side fuse panel using the fuse Emigration belongings endow on the panel. Disable the theft-lock operation on the radio.


2.4. Push the ignition switch approximately one inch toward the front of the vehicle so that it Testament halcyon the mounting bracket. Lift the switch up and away from carry on the instrument panel.



Remove the instrument Swarm by removing the bezel screws with a screwdriver and prying the bezel off with a prying factor or flathead screwdriver.3. Remove the two screws holding the ignition switch in berth with a screwdriver.


5. Disconnect the electrical connectors from the ignition switch. Assign the main in the ignition and turn it the Amble position.


6. Press the spring-loaded pin on the side of the ignition switch with a meager screwdriver. Pull the lock cylinder elsewhere by the fundamental.


Install the New Ignition Switch


7. Distance the ignition primary in the dewy ignition cylinder and push the cylinder into city in the ignition housing. Turn the fundamental to the off position and remove it.


8. Connect the electrical wires to the back of the ignition switch.


9. Put the switch assembly in position in the cluster and install and tighten the two screws with a screwdriver.


10. Install the instrument cluster bezel and attach the two screws with a screwdriver.


11. Replace the airbag fuse in the driver's side fuse panel. Connect the negative battery cable with a wrench. Enter the code for the Theft-lock system into the radio.