Keep you ever seen someone stuck on the side of the course with steam billowing outside of the hood? Most cases, this is thanks to their vehicle has blown a heater hose. Analysis both radiator hoses (upper and lower) and all heater hoses.3. When you catch the poor hose, intersect the damaging detail absent.
Instructions
1. After the engine cools down, remove the radiator cap. Settle it aside owing to you will need to transform it after you are done.
2. Evaluation all hoses for leaks. They are located throughout the engine. The steam comes from the vehicle coolant that leaks absent of the hose and is frying on top of the burning engine. This interrogation looks worse than it actually is. Simply, let the engine chill down by lifting the hood all the hang-up agape and accumulate your tools.
You Testament not essential to use the coupling if the leak is on the water pump or heater core. In this case, after you cut off the bad piece with your knife, re-clamp it to the proper fitting.
4. Put your coupling on the hose, if the leak is in the middle of the hose. If it will not slide on well, use a little coolant to lubricate it. Place the coupling on both ends tightly and clamp them into place. Make sure they are on good or you will have to begin over. Tighten the clamps but be careful with remainder of the hose. You do not want to puncture any more of it. Add coolant or a little water to receive it to the nearest store to buy some coolant and a new hose for your vehicle. Do not drive far.
5. Take your vehicle to a service center as soon as possible for proper replacement if you are not comfortable with replacing the hose yourself.
