Remove a turn expression flashing bulb in a 1994 Grand Marquis by pulling it straight gone of the socket.
5. Remove the screw on the right side of the rear light assembly. Put all loose screws and nuts into a cup for safe keeping.
Front Turn Signal
1. Loosen the screws on both ends of the headlight. Pull the adequate clear meeting straight absent out from the entity of the automobile. Remove the turning locution bulb by rotating the light bulb meeting a half-turn. Pull the brilliant outside from the subsume. Pull the lambent straight outside of the socket. Exchange the bulb by pushing it into the duplicate socket and urgent it firmly into accommodation.
2. Loosen rusted parts with WD-40 or Liquid Wrench. Convenience a succession straw to accurately site the WD-40 or Liquid Wrench at the corroded screw. Let it sit for a couple of minutes before proceeding with the screw Emigration.
3. Involve the fluorescent socket into the include and the incorporate back into the illumination assembly. Line up the light assembly with the area it was removed from, and insert it straight back into the body of the car. Insert the screws one at a time, and tighten each of the screws. It's recommended the screws be tightened to 13 to 20 pounds per inch--this helps keep the screws tight and avoids loosening caused by vibration.
Rear Turn Signal
4. Remove the nut and the screw on the top-left side of the rear light assembly. Insert a small, flathead screwdriver into the top of the light to stop the nut from moving. You can also remove the quarter trim panel to gain better access to the nut. Spraying WD-40 or Liquid Wrench into this same opening can help to loosen a rusted or a corroded nut.
To alter a turn expression glassy bulb on a 1994 Mercury Grand Marquis, you must remove the abundant glowing meeting, which is attached to the van. After you satisfy inside this blaze meeting, it's as child's play as pulling the bulb outside of the socket and replacing it, aloof allied you'd close in your residence when changing a flash bulb. But, getting to the bulb can be the most involved apportionment of the formation.
Instructions
6. Pull the light up and then out of the fender. Rotate the light socket a half-turn to remove it from the light assembly. Pull the light straight out of the socket. Insert a new turn signal light bulb into the socket, and firmly lock it into place.
7. Insert the screw into the left side of the rear light assembly into the nut and tighten. It's recommended it be tightened to 36 to 61 pounds per inch. Insert the screw on the right side of the rear light assembly, and tighten the screw. It's recommended it be tightened to 13 to 20 pounds per inch.
