Removing the starter on a Ford Focus is complicated by first off accessing the starter and then getting it elsewhere of the vehicle once it is disconnected. Slide the floor jack under the front aim and lift the Focal point up, positioning the jack stands under the frame. Lower the Bull's eye onto the jack stands. Remove remainder of the lug nuts and pull the shove off by fist.4.
Assign your safety glasses on. Fix the parking brake and unlatched the hood. Bag the battery terminal wrench to disconnect the con battery cable. Chock the honorable side rear circle.
2. Loosen the due front lug nuts with the lug wrench.
3. This capacity is easiest provided you acquire access to a lift, on the other hand can again be done on the ground by supporting the front confine on jack stands. Either road, expect to spend distinct hours on this specific repair.
Instructions
1.Climb under until you can gape the starter, which is visible over the rear of the hold together front spin fresh. Operate the socket set to disconnect the wiring harness going to the starter. Then unbolt the starter from the engine.
5. Use both hands to pull the starter out through the wheel well. You may need to turn it this way and that to find the proper angle that will allow you to slide it out.
6. Move the new starter into place, in reverse of how you removed the old one.
7. Bolt the new starter to the engine and reconnect the wiring harness using the socket set.
8. Reinstall the right front wheel and hand tighten the lug nuts.
9. Jack the Focus off the jack stands and then lower it to the ground. Once down, tighten the lug nuts to 85 ft/lbs with the torque wrench. Reconnect the negative battery cable.
