The dimmer switch on a 1991 Chevrolet Blazer is a multi-switch. One Testament come off from the top and the other Testament come off from the backside.3. Pull the turn signal lever outside while twisting it forward.
Removing the Old Dimmer Switch
1. Disconnect the contrary dynamism cable on the battery. The battery needs to be remoted while working on the electrical development.
2. Remove the steering edge shroud with a Phillips-head screwdriver. The shroud will come off in two pieces. This switch Testament function everything on your turn vocable lever. This Testament combine switching from grand and low beam lights, operating your windscreen wipers and using your turn word and the cruise direction. The switch is buried in your steering borderline, so removing it is due a complication of disassembling the steering contour to access the switch.
Instructions
The lever is connected to the multi-switch.
4. Remove the wiring harness running in back of the multi-switch. Field the wiring outside of the habit so you can remove the switch,
5. Unscrew the switch with a Phillips-head screwdriver. The switch Testament come gone once the screws annex been removed.
Installing the New Dimmer Switch
6. Install the recent switch. Tighten the screws to influence the switch securely.
7. Attach the wiring harness back to the switch. The harness should plug into the switch. Push the harness connector into the switch until it clicks into compass.
8. Install the turn term lever. Push in and twist it back toward the dash to lock it in place.
9. Place the steering column shroud back on the steering column. Be sure to tighten the screws to position the shroud in place.
10. Reconnect the battery. Crank your Blazer to test out the switch. Attempt to run everything on the switch to ensure you have a good multi-switch.
