The Acura Integra was sold between 1986 and 2007. Whether your antenna Testament not lower or elevate up, you Testament viable devoir to change the antenna Engine. A principles socket wrench, screwdriver and pliers are all that's needed for the installation.Lawns your Integra in a well-lit and dummied up earth, autonomous from distraction. Always disconnect the contrary battery cable before you crank electrical components. It's besides not unusual for the antenna motor to energy elsewhere.
Safety and Preparation
Generate firm you obtain the genuine tools and parts needed to install the antenna. Whether your antenna is physically damaged and you are simply replacing the antenna mast, reuse the existing antenna Engine. The 1998 Integra received a gentle makeover from the 1997 vehicle, however the better internal components remained the twin. All trim levels of the Integra included a guideline potency antenna between 1994 and 2001. For the most chunk, these directions Testament use to every Integra produced between 1994 and 2001, if the Integra is the sedan or the hatchback. Potentiality antennas can be damaged or jammed and Testament demand replacement.
Removing the Old Antenna
Remove your Timber liner to access the panels inside the Timber. The antenna Engine in your Acura Integra is mounted on the Chauffeur's side of the trunk. Once the liner is removed, take off the trunk liner.
Unplug the power antenna motor cable, lead and the harnesses attached to it. Wrap the base of your antenna (the nut around the bottom of the antenna mast) with a towel, and use a pair of pliers to twist it off. Once the nut is off, pull the old antenna lead up through the trunk. Re-use the old nut if it isn't damaged.
Remove the mounting bolts from the antenna motor and take it out, if you are replacing it. If not, leave it in and you can connect the new antenna lead to it.
Installing the New Antenna
Mount the new antenna motor if you are installing one. Use the existing mount and bolts; make sure the new motor is in the same position as the old one.
Feed the antenna lead through the antenna hole on your rear driver's side fender. Attach the antenna nut, wrap the towel around it, and then tighten it with the pliers.
Access your trunk again and connect the new antenna lead to the antenna motor. Reattach the connections and the primary power cable. Reconnect your negative battery cable to make sure the antenna works properly before replacing your trunk panel and liner.
