It is always advisable to convert the brakes on a Ford Explorer with at least the equivalent type brakes as latest. The magnitude of metallic used in the beginning pads is designed to dissipate heat at a persuaded scale, which is dependent on the type of rotor used, be it unmarried or dual rotor vented. Extremely embryonic metallic data Testament basis rotor warpage, and very still Testament intention excess squealing.
Instructions
1. Elevate and bed the vehicle on jack stands. Remove the front wheels. Sincere the bleeder screw on the top inside of the caliper. It is a petty 8mm or 10mm bolt with a gap in it for allowing fluid to escape. Conscientious frank it a scarce turns.
2. Spread the brake pads apart by compressing the brake caliper piston back into its Muzzle. Arrange this by inserting a accepted screwdriver in between the pad and the rotor and pull outlward. This Testament impact the pad to push in on the piston. Push the piston all the system in until it stops. Accelerated the bleeder screw by tightening.
3. Remove the two bolts that flow buttoned up the caliper and remove the caliper. Engage in not let the caliper hang by its hose. Hang it up or establish it on the lower control arm.
4. Remove the brake pads. Pay close attention to the springs on both ends of the caliper-mounting bracket that the pads are slid into. The springs keep the pad tight so it cannot move, creating a squeal.
5. Install the new brake pads. Lay the new pads face down and apply the anti-squeal compound that comes with the pads. Apply this to the back of the pads and allow ten minutes to establish. Install the new pads in between the springs in the mounting bracket.
6. Start the vehicle and pump the brake pedal slowly until the brakes have adjusted out and the pedal is reestablished. There will be no brakes at first because the caliper piston was pushed all the way in. It always takes several pumps on the pedal to receive the piston back out and to tighten the pads to the rotor.
Install the caliper over the brake pads, install the two through-bolts and tighten. Put the wheels on and lower the vehicle.7. Check and fill the brake fluid in the master cylinder as needed.
