Popular automotive starter with on-starter solenoid.
Most Toyota 4Runners carry the starter motor mounted to one side of the engine along the lower nature, as most vehicles bring about. Nevertheless, the Toyota 4Runner with the 2UZ-FE engine has the starter mounted on top between the two cylinder banks. To alternate the unit on this representation, you Testament posses to remove the intake manifold. Grasp in brainpower that this procedure applies to all 4Runners apart from the 2UZ-FE mould.
Instructions
1. Stadium your Toyota 4Runner in guarded community and continuous surface. Conduct the hood and disconnect the melanoid, con battery cable.
2. Lift the vehicle using a floor jack and brace it safely on 2 jack stands.
3. Remove the engine splash shield from underside the engine compartment whether your specific imitation is equipped with one. Appliance a wrench or ratchet and socket.
4. Fix the starter Engine under and to the right-hand side (passenger side) of the engine compartment. Disconnect the battery cable from the starter solenoid--the small cylinder on top of the starter motor--using a wrench or ratchet and socket. Then, unplug the electrical connector-thin wire-from the solenoid by pressing the small plastic tab at the connector and pulling the connector from the fitting.
5. Remove the mounting nuts or bolts securing the starter motor to the transmission bell housing using a wrench or ratchet and socket. Install the mounting nuts or bolts by hand first. Tighten the nuts or bolts to 29 foot-pounds (39 Nm).7. Plug the electrical connector and battery cable to the starter solenoid.
Pull the motor towards the front of the vehicle and lift the starter away from the engine compartment.6. Set the new starter motor in place, making sure the teeth on the starter motor pinion gear and the teeth on the flywheel mesh perfectly-otherwise the starter motor will grind against the flywheel and damage the unit.
Install the engine splash shield and lower the vehicle. Connect the black, negative battery cable and start the engine to make sure the new starter motor is working properly.
