Kenwood machine stereos are straightforward and dependable pieces of Accoutrement, designed to be installed by anyone with a decent acquaintance of a vehivle's electrical operation. When the chronology comes to upgrade them, you may desire to refer to a machine stereo able. Provided you understand what you're doing, nevertheless, you can remove a Kenwood automobile stereo moderately quickly, leaving the sprint time freebie for whatever different group of Accoutrement you intend to install in its domicile
Instructions
1. Turn off the vehivle and disconnect the wire from the contravening terminal of the battery. That prevents electricity from running wound up your van's manner and allows you to drudgery safely.
2. Detach the plastic frame encircling the Kenwood van stereo. It should pop off with a petite bland prodding from a small screw driver. Remove it with care so you don't accidentally mar its surface.
3. Slide a pair of stereo removal tools or radio keys into the two catch pins on either side of the stereo. There should be four pins in totem: two on the upper half of the slots and two on the lower half of the slots.
4.7. Disconnect the wires from the back of the stereo (you shouldn't need any tools for this). Remove them one at a time and mark which one goes where. You should see wires for the power control and antenna control, also as pairs of colored wires for the various front and rear speakers.
6. Insert the radio keys or stereo removal tools into either side of the car stereo and press gently but firmly inward. Slowly pull the stereo out using the tools.
Remove the rubber frame of the Kenwood stereo and set it aside.5. Unscrew the M4x8 screw on the back panel of the stereo to detach it from the dash frame. The exact configuration depends on your Kenwood stereo, but if you note each wire and its pertinent location, you shouldn't have any trouble reattaching them to the new stereo.
8. Pull the stereo free. It should now be completely disconnected.
