Transform a vehivle door with one from the equivalent representation.
There are a figure of problems that can befall with your Ford vehicle doors. The door can fall absent of alignment, normally now of arched or worn hinges that may itch either alignment or replacement. Second childhood of convenience can engender those problems. A child accident can damage the door itself and coercion you to exchange it. These tasks Testament normally desire at least two individuals with the exact method depending on the year and representation.
Instructions
Alignment
1. Loosen the bolts for the hinges at the door's cusp using a wrench.
2. Lift the door upward or downward to adjust the position. The door's top foot (not including the window frame) must range with the tops of the front fender, other door and/or rear quarter panel while the backside lines up with the lower rocker panel.
3. Tighten the bolts on the hinges while a moment adult holds the door in its genuine position.
4. Adjust the striker on the door pillar as needed, loosening its screws with a Torx wrench, tapping it in the equitable course and tightening the bolts.
Feed the electrical connectors through the door and reconnect the electrical connectors, ground wires and clips.12. Reinstall the inner trim panel and its trim bezels and handles.
6. Plain the door and help it on blocks or jacks.
7. Pry off all trim bezels on the inner trim panel, including the window lock controls whether equipped (for a handbook window, rub a rag remain the window Eccentric person to dislodge it). Remove the door panel's screws with a screwdriver, lift it off the door and disconnect its electrical connectors.
8. Unplug all of the door's electrical connectors, ground wires and harness retaining clips. Remove the rubber conduit from inside the door and pull all the wires out through the conduit hole.
9. Mark the hinges' positions using a scribe or pen, then remove the hinge bolts on the door's side. Remove the door from the hinges with another person's help.
10. Position the new door using the old door's scribe marks as a guide and bolt the hinges to the door.
11.
Door Replacement
5. Roll the window up all the hang-up and disconnect the vehicle's absent battery cable.13. Close the door and reconnect the battery cable.
Hinges
14. Perform all of the above steps in Section 2 to remove the door from the vehicle, just as you would for replacing the door. Have another person hold onto the disconnected door.
15. Remove the bolts for the hinge on the body side with your wrench and remove the hinges.
16. Install the replacement hinges in the same locations using their bolts.
17.Reconnect the door to the hinges using the steps in Section 2, starting with Step 6.
