Alter Brake Pads on a Dodge Intrepid
The Dodge Intrepid was a unabridged sized front trundle handle sedan produced from 1993 to 2004. Owing to of the dimensions and weight of the Intrepid it utilized CD brakes on both the front and rear axles. These CD brakes apply a pad comprised of friction data bonded to a steel backing plate. Over hour, the friction counsel can wear absent and the pads Testament exigency to be replaced.23. Check the fluid level in the master cylinder reservoir. Add brake fluid as necessary.
Removing the Wheels
1. Grassland the vehicle on a akin surface.
2. Levy rotate chocks in front and remain the rear wheels and tires.
3. Place the parking brake.
4. Loosen the lug nuts on both the front and rear wheels using a lug wrench. Discharge not turn the lug nuts else that one turn.
5. Uplift the front of the vehicle, using a floor jack and facilitate with jack stands placed underneath the front frame.
6. Lift the rear of the vehicle. Effect by positioning a floor jack underneath the rear frame. Elevate the jack, then field jack stands underneath the rear frame. Lower the jack.
7. Unscrew the lug nuts on both the front and rear wheels using a lug wrench. Lift all four wheels off the lug studs and step them elsewhere of the course.
8. Clear the crack cylinder reservoir and siphon approximately 2/3 of the fluid away using an aged turkey baster. You cannot convenience the baster for bread ever again.
Removing the Brake Pads
20. Retighten the lug nuts using a lug wrench.21. Check the fluid level in the master cylinder reservoir. Compress the C-clamp to drive the caliper piston back into its bore.
10. Unscrew the two screws that secure the brake caliper to the steering knuckle, using a socket. Do not remove the banjo bolt that secures the hydraulic brake line to the caliper.
11. Lift the caliper off the brake disc using your hands. Do not put stress or allow the caliper to hang from the hydraulic brake hose.
12. Pull the brake pads from the caliper using your hand.
Installing the Brake Pads
13. Pull the guide pin bushings from the caliper, using your hand. These are the bushings that the caliper retaining bolts slide through.
14. Coat the outside of the guide pin bushings with a multipurpose grease before reinserting them into the brake caliper.
15. Press the new pads into position in the brake caliper. Be sure the steel clip on the inboard pad fits into the caliper piston. Fit the steel clip on the outboard pad over the tabs on the outside of the caliper.
16. Drop the caliper into position over the brake pad.
17.Screw in the two bolts that secure the caliper to the steering knuckle, using a socket.
Installing the Wheels
18. Lift the wheels onto the lug studs, and screw on the lug nuts using a lug wrench.
19. Lower the vehicle.
9. Position a C-clamp over the brake caliper. Position the bottom of the clamp on the inboard side of the caliper. Position the top of the clamp on the outboard brake pad.
Add brake fluid as necessary.
22. Pump the brake pedal until pressure builds in the brake system (five to seven times). This will reset the pistons inside the brake calipers.
The manufacturer recommends replacing the pads on both front and rear wheels. Whether you hear a screeching or grinding sound whenever you exercise the brakes your pads could demand to be replaced, and waiting very extended could damage the rotors.
