Eclipse the XM antenna to construct it less in evidence to others that you keep a dependency radio method in your Motor lorry. A infrequent universal tools are all that is needed, extremely as some intimacy in working on the chassis of a Motor lorry. The Motor lorry Testament not be damaged in any conduct.
Instructions
1. Grassland the Motor lorry and be certain the emergency brake is on. Contain the gratuity of a flat-edged screwdriver into the Joint of one of the two plastic tabs on an string of the third brake glassy (the center-positioned brake light). Lift up on the tip of the screwdriver to remove the tab. Repeat this procedure on the other tab.
Trace the wiring from the brake light to the grommet inside the compartment. Pull the grommet out with your fingers.4.
2. Remove the screws from inside the tabs with a Phillips screwdriver. Pull the brake light out of the compartment on the truck.3.
Open the rear window of the truck from the inside. Pull the headliner down a few inches to break the Velcro seal that is in place.
5. Put the fingers of one hand between the headliner and the roof. Push the wire attached to the XM antenna through the hole in the grommet. Catch the wire as it comes through the grommet from inside the truck and pull it in.
6. Exit the truck. Place the XM antenna into the compartment. Place the brake light back on the compartment. Reattach the screws. Push the plastic tabs into the slots they were taken out of on the brake light. The XM antenna's wiring can now be connected to the XM satellite receiver that is inside the truck.
