The adept cylinder is located on the firewall- attached to the brake booster-inside the engine compartment on the Chauffeur side.
When we are driving down the highway surrounded by Stirring traffic at gigantic speeds, we touch trustworthy for the most atom on our intelligence to slow down and come to a abundant conclusion as we want. We can achieve all this on account of the skillful cylinder, a Element in the engine compartment in charge of developing gradual or immediate force in the hydraulic brake manner. Nevertheless once the masterly cylinder looses its know-how to flourish resistence or begins to leak, it must be changed. Our heart may depend on it. Here we Testament proceed from the Correct procedure to change the adept cylinder in your vehicle without still disagreement.
Instructions
1. Ajar the hood and compass a grasp pan underneath the vehicle appropriate in the trail of the crackerjack cylinder domicile.
2. Loosen, however do not disconnect, the four nuts that attach the brake lines to the master cylinder. Use a flare-nut wrench to avoid rounding off the nuts.
3. Remove the two mounting nuts that attach the master cylinder to the brake booster using a wrench or ratchet and socket.
4.10. Bleed the brake hydraulic system according to your vehicle service manual.
6. Cover the end of the brake lines with small plastic bags or pieces of plastic and secure them with rubber bands to prevent dust or foreign particles from entering the brake system. Wipe clean the lines and any other components from brake fluid spills using a clean rag.
7. Remove the plastic reservoir from the old master cylinder and install it in the new unit. Bleed the new master cylinder according to the manufacturer instructions.
8. Install the new master cylinder in place and start the brake line and brake booster nuts by hand first. Once the master cylinder is mounted in place and the brake lines attached, tighten up the nuts with a wrench.
9. Plug the electrical connector to the master cylinder.
Unplug the electrical connector from the master cylinder.5. Finish disconnecting the brake lines from the master cylinder. Pull the master cylinder from the brake booster mounting studs and, if necessary, play the master cylinder carefully form side to side to clear and remove it away-make sure no to bent or damage the lines.
