The fast Chevy Camaro was inaugural introduced in 1967 and is much a correct regular muscle van nowadays. Whether you compulsion to exchange the brake master cylinder in your Camaro, bench bleed the au courant one before installing it to receive the trapped air gone of the course and avoid forcing it into your brake lines. The manner isolated takes approximately 10 minutes and these directions operate to any representation year.
Instructions
Prepare the Master Cylinder
1. Uninstall the ancient skilled cylinder before you bench bleed the recent one. The stop of the cylinder varies slightly between contrastive mould elderliness, nevertheless generally, it sits prominently near the Chauffeur's side firewall on the Chevy Camaro.
2. Disinfected and reuse the dated brake fluid reservoir. Your advanced proficient cylinder may already come with one, so act whatever is most cost-effective.
3. Corner the advanced Chevy Camaro adept cylinder in a vice on your duty bench or table. Clamp it down firmly, production positive it's flush, so it doesn't articulation air pockets inside it during the manner.9. Look for air bubbles coming out of the hoses and depositing into the brake fluid in the reservoir. Keep pumping until all the air is out of the cylinder and bubbles no longer appear.
If your cylinder came with a reservoir, then it's most likely already installed.
5. Find the two fittings that came with your kit and screw them into the outlets on the side of the cylinder. Insert the two lengths of plastic tubing from the kit into the fittings.
6. Bend the hoses, so they aim into the brake fluid reservoir, then trim them so they'll stick about halfway down into it. Clip the two tubes to the reservoir to keep them in place to ensure you don't allow air back into the system.
Bench Bleed the Master Cylinder
7. Pour fresh DOT 3 brake fluid into the Chevy Camaro's reservoir; stop when you get just short of the maximum fill line. The hoses you attached should extend down into the fluid to make a miniature hydraulic system.
8. Put the screwdriver into the master cylinder and firmly push it against the piston to begin the process. Pump the piston to push the fluid through the cylinder and into the hoses. The fluid will cycle back into the reservoir, but since you used fresh fluid, it's okay.
Have your bleeder kit handy.4. Fit the reservoir onto the replacement cylinder, if you're reusing your old one or if you've bought a new one.
10. Leave the hoses in the reservoir and carefully remove the cylinder from the vise. Now you're ready to install the master cylinder into your Chevy Camaro.
