Hook Up a Contravening Ground in My Motorcar
The electrical action of a vehicle is needful to the system of the vehicle. When the electrical course fails, the plentiful vehicle Testament not manage. The step can fail for many reasons, including improperly wired additions to the process, accident or absence of basic maintenence. One of those prolongation issues for the electrical system is the colorless ground.1. Establish a suitable aim for the cutting edge ground connexion. Traditional locations for the grounding terminal are located on the frame inveigh of the vehicle, the firewall of the engine compartment or another speck within 24 inches of the battery that is metal.2.
This is the put where the adequate electrical method of the vehicle is grounded. Provided not properly cared for and protected, this connexion could fail and wish replacement.
Instructions
Remove the dye from the domicile with the sanding block and sandpaper. Create trustworthy the tint is removed in an universe 4 inches round. All of the colouring and primer needs to be removed, as Correct grounding requires naked metal for a worthy connexion.
3. Drill a 3/8-inch hole in the middle of the bare metal. This hole needs to be perpendicular to the mounting location to ensure the bolt will tighten flush against the surface.
4. Install the 3/8-inch bolt in the new hole. A self-tapping bolt will cut its own threads in the new hole. If a self-tapping bolt cannot be used, then the new hole will require threads to be cut with a thread tap.
5. Remove the bolt after tightening completely. Do not over-tighten, as this will damage the new threads.
6. Install the bolt through the hole on the non-battery terminal end of the new negative battery cable.
7. Tighten the bolt and cable in the new grounding hole. Make sure not to over-tighten the bolt and damage the threads. Thread locker can be used to ensure the bolt will not loosen from vibration.
8. Paint the cable end, bolt and bare metal around with the spray paint. This will help ensure the metal does not rust and weatherproof the new connection.
9. Attach the new cable to the battery.
