Masking is used to abbreviate off areas that surround the portray.
Masking Trim
Isolate window trim rubber and mouldings with 1-inch-wide masking tape. Pull back a slender chop of tape and handle it to one side of the trim.A extended Car whitewash assignment can be ruined by unsightly dye edges or over-spray caused by ineffective masking techniques. In known entity shops, Car preparers operate masking tape, masking paper and polythene sheeting to isolate contradistinct areas of a vehicle. This helps practise a neater connection that requires no detailing attempt once the tint has been applied. Colorful techniques are used on contrastive parts of a van to accomplish a known backwash.
Enjoy one finger on the site of the applied tape to blockade it from peeling outside while using the other participation to Proceeds expanded tape from the roll. Motion a finger along the length of the trim to place down the released tape, forming definite the borderline overlaps the trim perfect slightly without touching the surface to be painted. Keep on until the trim is completely covered before tucking in the overlapped edges with a plastic spreader.
Preventing Paint Build-Up in Apertures
Extend a cramped length of 1-inch masking tape across your knee with the adhesive side facing upwards. Pull the tape tight and adoption your thumb to fold one-sixteenth of an inch of masking tape back across itself so a little Joint is created. Unroll the tape across your knee, control the tape as tight as feasible throughout the fashion, to devise a elongated, single seam of tape. Apply the tape to the inner edges of auto panel apertures with the folded seam overhanging slightly to prevent material build-up when paint is sprayed.
Masking to Folded Lines
Block out areas above the crease of an auto body panel with tape and masking paper, but leave approximately half an inch of clearance on the fold itself. Take a roll of 1-inch masking tape and start at one end of the folded line. Apply the tape so half the width adheres to the uncovered section above the folded line, while remainder of the tape overhangs the panel. Use small pieces of tape at 1-inch intervals to fold the tape back on itself so a U-shape is created. Once the paint has been applied, carefully remove the single section of tape to eliminate the possibility of a paint edge during the drying process.
Custom Pattern Painting
Use 1-inch masking tape and paper to isolate all areas that do not require painting, but leave approximately one-eighth of an inch around the edges of the pattern. Take a roll of half-inch plastic masking tape and shape it to the edge of the pattern, pressing down the edges firmly so paint is unable to seep beneath it. Apply color to the vehicle and peel away the plastic tape before drying so a sharp and definable pattern edge is achieved. Leave the color to cure for 10 minutes before adding two applications of clear coat lacquer to eliminate the masking tape edge and create a gloss finish.
