The passenger side Gauze receptacle on a 1984 Chevy 3/4 ton 4x4 pickup, conscious as a K2500, provides the vehicle with almost twofold the fuel storage faculty of the average representation.6. Place the new gas tank on the floor jack by hand. Roll the jack and tank under the Chevy by hand.7.
Instructions
1. Manage the Chevy's hood and block it with the prop rod located inside the engine beefy. Remove the balky battery cable from the Chevy's battery terminal using the battery wrench.
2. Slide the floor jack under the passenger side of the Chevy's Bedstead. Uplift the jack purpose until it touches the underside of the Gauze cistern.
3. Unbolt both gas tank retaining straps using a socket set. Lower the tank slowly until you can reach above it and disconnect the fuel lines manually.
4. Lower the tank remainder of the way using the floor jack. Roll the floor jack and gas tank out from under the Chevy by hand.
5. Lift the old tank up and off the floor jack by hand. Set the old tank on a flat, level surface.
The additional receptacle, with the additional competence, brings the added convenience of longer trips between fueling stops. This besides allows the K2500 to peregrination far-off distances over ranch land and wilderness without abhorrence of running outside of fuel before returning to a Gauze station. Any able bodied workman who's mechanically inclined can transform the passenger side Gauze cistern on a 1984 Chevy 3/4 ton 4x4 in approximately two hours.
Lift the new gas tank up into position with the floor jack. Connect the fuel lines to the new tank manually.
8. Push the fuel tank retaining straps into position by hand. Bolt the retaining straps in place using the socket set. Pull the floor jack out from under the Chevy by hand.
9. Reconnect the Chevy's battery cable and close the hood.
