Test your brake pads regularly and exchange as needed.
Replacing the rear brakes on a 2000 Jetta is factor of the routine concervation for the vehicle. The brake method is a important Element of your machine, needed to providing a unharmed driving involvement. Remaining vigilant and replacing the rear brakes at the ahead communication that they are draining gone can comfort save you capital and headaches in the enlarged dart. For the popular driveway mechanic, this effortless business can be completed in approximately an time.
Instructions
1. Berth the Jetta in stadium, or in reverse provided the vehicle is equipped with a book transmission.8. Raise the vehicle with the jack high enough to allow the removal of the jack stand and the replacement of the rear wheel. Position the rear wheel and install the lug bolts.
Loosen the lug bolts one rotation with the lug wrench before raising the revolve. Employ the jack to lift the vehicle until the rear wheel is slightly off the ground. Remove the lug bolts and remove the circle and place them to the side. Position the jack stand where it Testament safely cornerstone the vehicle while allowing you clearance to drudgery. Lower the jack until the vehicle is securely supported by the jack stand.
3. Place the drain pan beneath the wheel assembly. Use the brake system cleaner to clean the brake assembly. Let the brake assembly dry and move the drain pan. Do not use compressed air. Brake dust is harmful if inhaled.
4. Remove the caliper mounting bolts while holding the caliper slide pins with an open-end wrench. Remove the caliper and suspend it from a length of wire or string. Do not let the caliper hang from the brake line.
5. Remove the old brake pads and the pad retaining springs from the caliper mounting bracket. Install the new retaining springs and the new pads. If the replacement pads you purchased are equipped with an adhesive backing, remove the foil before installation.
6. Retract the caliper piston with your brake piston tool by rotating the piston clockwise while pushing it back into the caliper housing. Different tools are available that make this job easier. The piston must be fully retracted to provide room for the new pads.
7. Place the caliper back into position on the caliper mounting bracket. Install the mounting bolt and tighten using 26 foot-pounds of torque.
Bring about not engage the parking brake. Distance the turn chocks closest to the front tires to prevent the vehicle from rolling. Provided you don't posses turn chocks, operate bricks or brief wood blocks.2. Tighten the lug bolts until the wheel is firmly seated. Lower the vehicle and verify the wheel lugs are tight.
9. Repeat this procedure on the other rear tire. Remove the wheel chocks. Apply the parking brake after both sides are complete.
