Repair a Dodge Dakota Door Latch
Whether the door lock on your Dodge Dakota Motor lorry is broken or otherwise not working, it leads to a brimming puzzle. You exigency to repair the door by replacing the fastening, which requires you to yawning up the door and extent inside it. The exact advance can vary depending on the year of your vehicle, chiefly with the figure and magnitude of the screws you must remove.
Instructions
1. Roll the door's window all the habit up and then disconnect the refusal battery cable. Provided the Dakota uses jotter windows, you can perform these tasks in reverse course.
2. Pry off the effectiveness window management switch with a trim stick, or disconnect the handbook window Eccentric person by rubbing a rag carry on it until the clip disengages. Remove all other bantam trim panels on the leading door panel.
Connect the electrical connector and the link rods to the latch.7. Fasten the window run channel back in place, install the door trim panel in the reverse order of installation, and connect the battery cable.
Unscrew the fasteners for the window's rear glass amble channel, located near the top and backside of the door -- this should desire a Torx wrench. Deed the channel out from the catch so you'll have more room to work on the latch.
5. Rotate the plastic retaining clips off the rods, detach the latch links and disconnect the electrical connector. Remove the three mounting screws on the outside of the door with the correct-size Torx wrench (you may also need an impact-type screwdriver to loosen the screws) and remove the latch from the door.
6. Insert the replacement latch within the door and secure it with the mounting screws.3. Remove all the retaining screws to the door trim panel using a Phillips screwdriver, pull the panel upward to Proceeds its hook from the door, and disconnect all wiring harnesses and the stock link rod. Peel back the plastic hose shield ultimate the panel.4.
