You can get a awash dispute with your babyish Ford Focus whether the thermostat is not working equitable. Use a 10mm open-end wrench and a 13mm socket to remove the bracket holding the exhaust gas recirculation (EGR) tube. Push EGR tube down to access thermostat housing.4. Use pliers to loosen the clip at the engine-end of the upper radiator hose where it meets the thermostat housing.
Conceive definite the engine of your Ford Polestar is air-conditioned. Bag jack and jack stands or revolve ramps to lift the front of your Meeting place. Turn radiator cap approximately 1/4-turn to Proceeds impulse in the cooling transaction. Remove cap when hissing stops, indicating power is relieved.
2. Set radiator draincock on the passenger-side of the backside of the radiator, facing the rear of the Target. Attach a hose to the plug if desired to play down coolant spillage. Loosen the plug to drain coolant into a suitable container. Reuse coolant if relatively new and clean.
3. Press the retaining clip on the bottom of the coilpack wiring harness upwards while pulling the plug toward you to unplug the harness. Happily for Focal point owners, Ford has make-believe changing the thermostat a relatively fast, painless procedure. In less than an age, you can be back extreme the shove of your Ford Focal point.
Instructions
1.Pull the hose off the housing. Take out two bolts holding housing cover and remove cover.
5. Note the position of the old thermostat. Pull out the old thermostat and seat new thermostat into thermostat housing in the same position. Clean any residue from inside the housing cover. Place new gasket over the thermostat and replace housing cover.
6. Reattach radiator hose, EGR tube and bracket and the coilpack wiring harness. Refill the radiator with reserve or new coolant. Start your Focus and allow the engine to warm up. Check for leaks.
