On the bazaar owing to 1984, the Dodge Company is a minivan manufactured by Chrysler.1. District an method for a just out reservoir from the parts supplier for your Dodge Caravan. Some dealerships may have a replacement reservoir in stock for purchase; otherwise, ask them to order one for you. Ordering the reservoir before you dismantle the car saves you from having to dismantle it twice and you can always take it back if you don't need it.
If you hold a latest Van or an older pattern, interest the windscreen Disinfected is a unabridged future chore, aided by using your windscreen washer fluid. Nevertheless, whether you recently comprehensive your washer reservoir and initiate it's empty when trying to end it, you probably carry a leak and you extremity to locate or exchange it.
Instructions
2. Turn the car off and remove the keys from the ignition. Pull the hood release handle beneath the instrument panel of your Dodge Caravan. Exit the car, walk around to the front, reach under the center of the hood and locate the auxiliary release latch. Twist it to the left to open the hood.
3. Raise the hood until the hydraulic hood catches and it stays open on its own. Locate the windshield washer fluid reservoir, which is on the left side of the engine compartment next to the large air-cleaning filter.
4. Disconnect the negative cable on the battery and the connectors from the front rear and level sensors. Remove the right front wheelhouse splash shield in order to get to the windshield washer reservoir in your Dodge Caravan. To do this, take off the five plastic rivets holding the wheelhouse splash shield. This will give you complete access to the windshield washer reservoir.
5. Remove the hose and any other leads from the reservoir and unbolt the tank. You should then be able to lift the reservoir out of your Caravan. Throw away the seals--you'll need to replace these when you install the new reservoir.
6. Screw in the new windshield washer reservoir to install it. Reattach the hose and other leads for the windshield washer reservoir and replace all the seals. After that's complete, reassemble the wheelhouse splash shield by reversing the order in Step 4 and reconnect the connectors on the front rear and level sensors and the negative cable on the battery.
