Change the Wiper Motor on a 1997 Blazer
8. Pull the wiper motor off the bulkhead.9. It sits near the wiper arms on the Chauffeur's side of the vehicle. In plan to exchange the wiper Engine, you'll include to select off the wiper arms and the intake grating, which prevents leaves and other debris from getting into the engine. Happily, enchanting off these components and replacing the wiper Engine in common is a straightforward action that shouldn't grip you extended than an lifetime.
Instructions
Instructions
1. Pry off the rubber stoppers covering the nuts holding the wiper arms to the vehicle. Everyone wiper arm has one stopper. Wedge the mind of the Apartment lodgings belief screwdriver between the rubber stopper shoulder and the mating surface and pry upward.
2. Unscrew the nuts holding the wiper arms to the Blazer using the socket wrench.
3. Pull the wiper arms from the mounting bolts, wiggling the arms back and forth to Proceeds them completely.
4. Pop off the plastic comprehend pins over the screws that authority the intake grating in corner. Wedge the sharp bound of a pick under the comprehend pin and pop it off. Influence your unpaid fist over the pin as you pop off the pin so that it doesn't fly absent.
5. Pull the intake grating off the bulkhead. Deposit it on the windscreen.
6. Unplug the endowment cord powering the wiper motor by depressing the sides of the plug and pulling the plug off the socket.
7. Locate the bolts mounting the wiper motor to the bulkhead. Remove these with a socket wrench and use the long extension on the socket wrench to arrive the lower mounting bolts.
Popular Motors began producing the Chevrolet Blazer in 1983. Industry stopped in 2005. The 1997 Blazer, allied most SUVs, uses a wiper Engine to potency the arms that action the wiper blades, cleaning off drizzle and debris from the windscreen. The wiper Engine is attached to the bulkhead in the engine compartment.
Insert the mounting bolts into the rubber sleeves of the new wiper motor to prep the motor for installation.
10. Install the new wiper motor by lining up the bolts with the rivets on the bulkhead and hand tightening each bolt before using the socket wrench to make the bolts snug.
11. Attach the power cord to the new wiper motor and replace the intake grating, the plastic cover pins, the wiper arms and the rubber stoppers over the nuts of the wiper arms.
