Silver a Fuel Pump in a Dodge Ram
Bed the vat by raising a transmission jack or floor jack underneath it. Provided you practice a floor jack, area a block of wood on the jack intellect to protect the container.5.
Removing the Fuel Tank
1. Benefit the coercion in the fuel system--remove the filler cap to aid power in the container, then remove the fuel pump relay in the fuse box. Eccentric person the engine for diverse seconds and gun for it to stall after running for a meagre seconds or not foundation at all. Disconnect the abrogating battery cable.
2. Lift the rear objective of the Motor lorry and block it on jack stands. Provided you annex a four-door Ram with a six-foot Bedstead, remove the left rear spin.
3. Disconnect the hoses from the metal pipes on the fuel and EVAP lines by loosening their clamps with a flat-blade screwdriver.
4.The Dodge Ram's fuel pump is contained within a module inside the fuel receptacle; to exchange the pump module, you must remove the fuel tank from the Motor lorry. While idiosyncratic components in the module, cherish the fuel comparable sending unit, can be changed gone, it is yet easier to convert the module as a full.
Instructions
Unstrap the receptacle from the vehicle by removing the nuts on the straps with a wrench. Lower the jack until the vat is low Sufficiently for you to disconnect the electrical connector and the fuel work border from the fuel pump module. Disconnect these and remove the tank.
Changing the Pump Unit
6. Clean the surface of the fuel tank with acetone or lacquer thinner, especially around the pump module, to prevent contaminants from entering the tank.
7. Disconnect the fuel line from the fuel filter and pressure regulator by depressing the quick-connect fitting tabs. Unplug the electrical connector by pushing the lock toward the fuel line fitting and depressing the release button.
8. Turn the lock ring on the fuel pump module with a large pair of pliers. You can also tap on the lock ring with a hammer and drift, turning it clockwise. Unscrew the ring once it is loose.
9. Lift the fuel pump module carefully out of the tank. Check the condition of the rubber gasket on the mounting hole and replace it if it is cracked, torn or damaged in any way.
10. Install the new fuel pump module within the tank, rotating it so the alignment arrow on the module lines up with the middle of the three hash marks on the top of the tank. (The fuel pipe on the filter/pressure regulator must also point toward the driver's side of the truck.)
11. Re-attach the lock ring on the module, using the pliers or the hammer and drift to tighten it.
12. Re-connect the fuel tank onto the truck and connect all the lines to the tank in the reverse order of removal. Replace the wheel if you removed it, and lower the truck once the tank is secure.
13. Connect the negative battery cable and the fuel pump relay. Turn the ignition switch to the "On" position for two seconds. Turn it back off for five seconds. Repeat several times. (This will re-pressurize the fuel system.)
