Install Wood Rails
on a Pickup Bedstead
Properly installing wooden rails in your pickup Bedstead allows you to extend the heighth of the Bedstead and haul loose objects such as wood or concrete blocks that otherwise would fall over the side. Improperly installing wooden rails Testament not buttress the extra weight and you could damage your Motor lorry or other cars during transport. Grasp sheltered, secure ways to install wooden rails on your pickup Bedstead.
Instructions
1. Degree the breadth of the castigate holes along the length of your pickup Bedstead.
2. Obtain a hardwood, such as Oak-tree. Ensure they fit tight enough within the rails so that the wood doesn't move.5. Drill a 1/2-inch hole in each rail halfway up the length of the protruding rail.
Shorten the rails to magnitude using the table adage.
4. Hammer the rails into the censure holes using the rubber mallet. Cook not obtain a soft wood, such as pine. Hardwoods presentation else load-bearing coercion than soft woods.3.
6. Ask a friend to help you level a two-by-four along the rails. Make sure to hold it in place once you level it.
7. Drill bolt holes into the two-by-four using the drill and the 1/2-inch drill bit. Make sure they align with the pre-drilled rail holes.
8. Connect the two-by-four rails to the rail posts using 1/2-inch bolts. Make sure to use two washers per bolt.
9. Tighten the nut with your fingers, then tighten it completely with a 1/2-inch ratchet.
