Tuesday, August 4, 2015

Replace Starter Motor For 1999 Ford Escort

Alternate Starter Engine for 1999 Ford Convoy


Ford designed the starter on your 1999 Convoy to endure for a character of senescence before replacement, however adore most other mechanical components, it Testament eventually fail. The most regular letter of an sick starter motor is the clunking and clicking that accompanies the turn of the vital. It is a skilled conclusion to transform the starter Engine before it is unable to begin your motorcar, a rundown that could sanction you stranded on the side of the course at the worst feasible bit.


Instructions


Removal


1. Disconnect the annulling battery cable to prevent shock and injury. Remove the accelerator cable routing bracket, located on the engine block.


2. Remove the air intake tube from the intake manifold. Allot and remove the top-side mounting bolts for the starter.


3. Hoist the machine with a floor jack, as you Testament compulsion access to the underside of the engine bay. Assist the motorcar with two jack stands for safety.


4. Remove the intake manifold starter cornerstone and locate the "S" terminal connector on the starter solenoid. Remove the connector by pressing on the plastic tab while pulling the connector assembly off.


5.10. Remove the jack stands from underneath the car. Lower the car and test the new starter by cranking up the car. If successful, the car should start with no difficulty.




7. Place the new starter motor into position. The starter motor should be fitted securely in its mounting base. Insert and torque the top-side mounting bolts of the starter into place.


8. Reconnect the "S" terminal connector and the "B" terminal wire to the starter solenoid. Insert and torque the remaining starter mounting bolt.


9. Reconnect the accelerator cable routing bracket. Replace the air intake hose and reconnect the negative battery cable.


Locate the "B" terminal wire on the starter solenoid. Loosen the nut holding the wire in place and remove the wire.6. Remove the remaining mounting bolt for the starter. Carefully move the starter motor out of position and out of the engine bay.

Installation